1. Establish the bottom of the rough opening as shown in figure 1 by the chart on this page.

2. Cut opening between the studs as shown in figure 2.

3. Shim sides of cabinet and attach the unit to studs with four 1-1/2 inch screws through the sides of the cabinet near the top and the bottom.

4. Install the door with the hinges provided to the desired swing.
(Detail of Self Closing Knife Hinge)

5. Finish with paint or stain to fit you decor.

Wiring of optional electrical packages should be done by an electrician. The wire should enter the Hide-A-Board in the upper left hand corner.